HEYHAIL factory photos showing the orange blower outlet, blue inflation tube, buckle strap, 26-inch tube opening circumference, and 2.4–2.8-inch strap offset.

How to Connect a Blower to a Commercial Inflatable

On the HEYHAIL commercial inflatable shown here, the blue inflation tube slides over the orange blower outlet. A webbing strap wraps around the tube and tightens through a buckle to hold the connection in place. Our factory photos show where the tube sits on the outlet and where to measure the opening and strap position.

How the inflation tube connects to the blower

  1. Identify the two parts. The blower outlet is the orange opening on the blower housing. The inflation tube is the blue fabric sleeve attached to the inflatable.
  2. Slide the tube over the outlet. With the blower off, fit the open end of the sleeve over the outlet. The tube should surround the outlet, with the strap and buckle accessible.
  3. Tighten the buckle strap. Pull the webbing through the buckle until it sits snugly around the tube. The close-up shows the buckle resting on the outside of the sleeve.

Use the setup instructions and blower specifications for your particular inflatable before operating it.

Blue inflation tube fitted over an orange blower outlet, with the gray webbing strap tightened through a metal buckle.
The blue inflation tube fitted over the orange blower outlet, with the webbing strap tightened through the buckle.

Two measurements from the HEYHAIL factory demo

Approximate measurements on the unit shown
What we measured Approximate size Where to measure
Inflation tube opening circumference 26 in (66 cm) Around the open end of the blue fabric sleeve. The factory photo shows the sleeve laid flat at about half that measurement.
Distance from the tube opening to the strap 2.4–2.8 in (6–7 cm) From the edge of the sleeve opening to the nearest edge of the webbing strap. The double-headed arrow in the photo marks both points.
A tape measure and a double-headed arrow show approximately 6–7 cm from the blue tube opening to the edge of its webbing strap.
On this sample, the tube opening edge is about 2.4–2.8 in (6–7 cm) from the nearest edge of the strap.

Will the same blower fit another inflatable?

Fit depends on the inflatable model and the blower outlet’s shape and size. The 26-inch measurement refers to the fabric tube’s circumference. For a replacement blower, check the model’s required blower specifications and compare the outlet dimensions and shape with the tube opening.

If you’re ordering a unit or checking a replacement, contact HEYHAIL with the inflatable model, the blower model, and photos of the outlet and tube opening. Include a tape measure in the photos so our team can see where each measurement starts and ends.

Explore more inflatable construction and setup guides from HEYHAIL.

Back to blog